Surface Prepartion

The concrete surface must be clean and free of all loose material, oil residue and have no sealers or paints. Clean thoroughly by using a pressure washer with a degreaser or stripper if necessary. Etch the surface using 1 part muratic acid to 2 parts water. Neutralize with an ammonia or baking soda and water solution, rinse thoroughly and allow to dry.

Mixing Instructions

In a clean 5 gallown pail measure 1 1/3 gallons of clean water (and add color pack at this time). Using a dripp with a mixing wand, slowly add the dry Spray Coat to the water as you are running the mixing wand. Once you have added all the material, continue to mix thoroughly for 2 minutes to a plastic consistency with no lumps. For smaller portions use enough water to mix to a plastic consistency.

Application Instructions

Patch & Leveling

Start by misting the surface with water, (surface should be damp only, no standing water) and then apply the Patch-It compound. Screed where necessary, smooth with a round edged fresno or pool trowel, keeping all tools clean and moist, and finish as desired. If the area to be patched is thicker that 1″, two or more applications may be necessary. Wait until the first application is dry, (1-3 hours) and then reapply.

Base Coat

Using a steel trowel or a squeegee apply an even coat of the desired color Spray Coat about 1/16″ thick. Allow to dry before continuing.

Spray Coat

Using a hopper gun and an air compressor set at around 20 pounds, shoot the top coat of Spray Coat material. Before the material sets all the way, pass a pool trowel across the surface creating flats as you go along.

Finishing

After the surface is completely dry, lightly scrape the deck with a flat floor scraper. Blow off any debris and seal. Toll or spray 2-3 coats of Renew-Crete Hi-Gloss Sealer. Allow 24 hours for foot traffic and 48 hours for auto traffic.

Coverage

45 pound unit covers 100 – 150 sq. ft.

Product Specifications

ASTM C-109 — Compressive Strength
1 day — 4266 psi
7 days —5675 psi
28 days — 6523 psi

ASTM C-882 — Compressive Strength 7 days — 1788 psi

 



For Professional Use Only. Keep Out of Reach of Children
Avoid contact with skin, wash exposed areas promptly. Wear eye protection. If Spray Coat gets in eyes, flush with clean water and seek medical attention. Contains silica sand, do not inhale Spray Coat. Wear a dust mask or suitable breating apparatus.

Limited Warranty
This product is warranted to be of uniform quality within manufacturing tolerances. Since no control is exercised over its use, no warranty expressed or implied, is made as to the effect of such use. Seller’s and manufacturer’s obligation under this warranty shall be limited to refunding the purchase price of that portion of the material proven to be defective.